LEGAL DISCLAIMER
Dimensions

All dimensions, whether given in metric or imperial, are liable to be rounded up or down to the nearest whole number. Improvements In common with most manufacturers Jonathan Charles Furniture operates a policy of constant improvement and therefore reserves the right to make changes to any item without notice.

Appearance & Finish

Jonathan Charles masterpieces are manufactured to the highest standards. However, the unique nature of wood and the other materials that are used in production means that no two pieces of furniture will be exactly alike. Jonathan Charles Furniture makes every effort to ensure that each item is produced to our exacting standards, but cannot be held responsible for slight variations in finish, colour and general appearance.

The polishers and finishers at Jonathan Charles Fine Furniture are skilled in creating consistent finishes across all products and materials. However, the individual nature of the materials used in the construction of our furniture means that no two pieces of furniture are exactly alike. Similarly, the images in this publication are as accurate as your monitor is calibrated but customers are reminded that colours and finishes may vary according to the unique nature of each item of furniture.

For specific colour matching requirements please contact the Customer Service Department. Please note: The Finish Codes used by Jonathan Charles Fine Furniture are used as a guide to the appearance of the furniture and should not be used to determine the specific materials used in the construction of an item of furniture.

Customer’s Own Material (C.O.M.)

The Jonathan Charles Upholstery Department accepts C.O.M. for most dining chairs, occasional chairs, stools and benches. In most cases one square yard/metre of fabric is required to upholster the seat of each dining room chair, although exact requirements will depend on the fabric width and pattern repeat. For certain items or in cases of unusual or difficult fabric patterns additional material may be required. Any unusual or special cutting requirements must be requested in writing and a full-width fabric repeat sent to the Customer Service Department in order for a quotation to be provided. The customer is responsible for shipping C.O.M. to our Upholstery Department.